This manual page is part of the POSIX Programmer's Manual. The Linux implementation of this interface may differ (consult the corresponding Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
fputwc — put a wide-character code on a stream
wint_t fputwc(wchar_t wc, FILE *stream);
The functionality described on this reference page is aligned with the ISO C standard. Any conflict between the requirements described here and the ISO C standard is unintentional. This volume of POSIX.1‐2008 defers to the ISO C standard.
The fputwc() function shall write the character corresponding to the wide-character code wc to the output stream pointed to by stream, at the position indicated by the associated file-position indicator for the stream (if defined), and advances the indicator appropriately. If the file cannot support positioning requests, or if the stream was opened with append mode, the character is appended to the output stream. If an error occurs while writing the character, the shift state of the output file is left in an undefined state.
The last data modification and last file status change timestamps of the file shall be marked for update between the successful execution of fputwc() and the next successful completion of a call to fflush() or fclose() on the same stream or a call to exit() or abort().
The fputwc() function shall not change the setting of errno if successful.
Upon successful completion, fputwc() shall return wc. Otherwise, it shall return WEOF, the error indicator for the stream shall be set, and errno shall be set to indicate the error.
The fputwc() function shall fail if either the stream is unbuffered or data in the stream's buffer needs to be written, and:
- The O_NONBLOCK flag is set for the file descriptor underlying stream and the thread would be delayed in the write operation.
- The file descriptor underlying stream is not a valid file descriptor open for writing.
- An attempt was made to write to a file that exceeds the maximum file size or the file size limit of the process.
- The file is a regular file and an attempt was made to write at or beyond the offset maximum associated with the corresponding stream.
- The wide-character code wc does not correspond to a valid character.
- The write operation was terminated due to the receipt of a signal, and no data was transferred.
- A physical I/O error has occurred, or the process is a member of a background process group attempting to write to its controlling terminal, TOSTOP is set, the calling thread is not blocking SIGTTOU, the process is not ignoring SIGTTOU, and the process group of the process is orphaned. This error may also be returned under implementation-defined conditions.
- There was no free space remaining on the device containing the file.
The fputwc() function may fail if:
- An attempt is made to write to a pipe or FIFO that is not open for reading by any process. A SIGPIPE signal shall also be sent to the thread.
- Insufficient storage space is available.
The following sections are informative.
Section 2.5, Standard I/O Streams, ferror(), fopen(), setbuf(), ulimit()
The Base Definitions volume of POSIX.1‐2008, <stdio.h>, <wchar.h>
Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2013 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 7, Copyright (C) 2013 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. (This is POSIX.1-2008 with the 2013 Technical Corrigendum 1 applied.) In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.unix.org/online.html .
- A request was made of a nonexistent device, or the request was outside the capabilities of the device.
Any typographical or formatting errors that appear in this page are most likely to have been introduced during the conversion of the source files to man page format. To report such errors, see https://www.kernel.org/doc/man-pages/reporting_bugs.html .